To configure net management port For SunFire X2200
Step1:- connect the m/c to laptop through DB9 cable and open hyperterminal.Step2:- Login Prompt will appear default login id & passwd. ( root & changeme)
Step3:- The system BIOS setup screen. Choose Advanced - >IPMI 2.0 Configuration - >Set LAN Configuration - > IP address- > save this and boot the m/c.
Step4:- Run below following command.
show /SP/AgentInfo
start /SP/AgentInfo/console
set /SP/AgentInfo Gateway=gateway
Step4:- After doing all this ping the ip address to verify & ssh to the same.
Step5:-Open a browser m/c should be accessible now https://ipaddress
If you found any issues Please refer the below commands
set /SP/AgentInfo DhcpConfigured=disable
set /SP/AgentInfo NetMask=netmask
set /SP/AgentInfo Gateway=gateway
set /SP/AgentInfo IpAddress=ipaddress
1. Reboot the system by typing the following command from the SP CLI:
set /SP/SystemInfo/CtrlInfo PowerCtrl=reset
2. Launch the console from the SP using the following command:
start /SP/AgentInfo/console
http://docs.sun.com/source/819-6596-12/Chap2.html
No comments:
Post a Comment